HP LaserJet Pro M404dn Setup Guide

The HP LaserJet Pro M404dn is a wired-only laser printer — no built-in wifi — which surprises many buyers. This guide covers both ways to set it up: direct USB for a single computer, and Ethernet for shared office printing, plus the 123.hp.com driver installation that applies to every HP printer.

HP Setup · Monochrome Laser Printer · All setup guides

Step 1: Unbox and load

Remove all orange packing tape, slide in the toner cartridge until it clicks, and load the 250-sheet tray with plain paper.

Step 2: Download drivers from 123.hp.com

Go to 123.hp.com/setup on the computer, type "M404dn", and download the HP Easy Start installer — it detects the printer and installs the correct driver automatically.

Step 3: USB setup (single computer)

Connect the USB cable when the installer prompts you. Print a test page from the installer to confirm.

Step 4: Ethernet setup (office sharing)

Connect an Ethernet cable from the printer to your router or switch. The printer pulls an IP address automatically — find it on the control panel under Network Settings.

Step 5: Install on other computers

On each office computer, run the same 123.hp.com installer and choose "Network printer" — the M404dn appears on the list automatically.

Step 6: Mobile printing

Because there is no wifi, print from phones by sending the job through a computer on the network, or add an HP wireless model like the OfficeJet Pro 9135e for direct phone printing.

Stuck on a step?

No wifi on this model: if wireless printing matters, see our wifi alternatives below. Book a free consultation and we'll walk you through it — or book a setup appointment and we'll do it for you.

Buying this printer?

Want wifi instead?

The M404dn is wired-only. If you need wireless printing, the HP OfficeJet Pro 9135e or HP ENVY 6455e connect over wifi with the same 123.hp.com setup flow.

Book a Setup Appointment